Front Panel Operation; Power On / Off; Adjust Knob And Enable Button; Figure 2.2 - Front Panel Display - Newport LDC-3706 Series User Manual

Front Panel Operation

General Operation: This section describes the fundamentals of operation for the LDC-3706 Laser
Controller. The order of descriptions will follow the normal progression of how the user would
typically configure the instrument for use for the first time.
Figure 2.2 – Front Panel Display

Power On / Off

The POWER button toggles between power on and standby power (off).

Adjust Knob and Enable Button

The ADJUST knob and enable buttons (TEC and LAS located below the ADJUST knob) is located
on the upper right side of the LDC-3706 front panel. It is used to change the setpoints, enter
parameter values, enter the GPIB address, enter Save or Recall bin numbers or enter instrument
calibration data. The enable button LEDs indicate the three modes of operation of the knob: Disabled
(both LEDs off), TEC adjustment enabled (TEC LED on), and LASER adjustment enabled (LAS LED
on).
December 2019 19 LDC-3706 Series Laser Controller