Bus Sx - FUTABA T4PM Instruction Manual

Connection between wired transmitter and servo
Connection between wireless receiver and servo
(HOME screen)
Using the S.BUS servo function
(Preparation)
- Connect S.BUS or S.BUS2 servo with reference to the above connection diagram.
- Connect the battery to a S.BUS/S.BUS2 servo.
- Be sure to use the wired method when changing the setting of SR mode. The mode can not
be changed with wireless setting.
1
Turn on the power switch of the transmitter.
In the case of wireless, turn on the battery switch of the receiver and check the operation of
the servo. The S.BUS SX screen is displayed.
Dual servo extension cord
Connecting S.BUS/S.BUS2
servo and battery to the trans-
mitter Communication port.
W-CH: CH2
W-CH: CH1
(MENU 2 )
MENU-1
MENU-3
MENU-4
S.BUS Link Function "S.BUS SX"
Servos connected to Ch3
/ Ch4 of the receiver can
not be set wirelessly.
(S.BUS SX screen)
Select
"S.BUS SX"
Setup item
READ: Servo's data read.
WRITE: Writing the data to servo.
RESET: Initialization
- Select with the (+) or (-) buttons.
Battery
77