FUTABA T4PM Instruction Manual page 31

*When using an S-FHSS system ("SFH") receiver (R2104GF, R204GF-E, etc.), after reach-
ing this point set the transmitter power switch to OFF and go to "Receivers other than T-
FHSS" on page 31.
3
Bring the transmitter and receiver to 20 inches (half meter) of each other (do not allow the
antennae to touch) and turn on the receiver power.
4
Press the T4PM transmitter's (JOG) button up or down to move the cursor to "LINK: EXE".
When the (JOG) button is pressed for approximately 1 second, "PUSH RX LINK SW" ap-
pears on the screen and a 20 second
countdown begins. Countdown can
be canceled at any time pressing the
(JOG) button up / down or left / right.
5
During the 20 second countdown, push up the receiver side Link switch for approximately 2
seconds. The LED will begin to blink red. After the receiver LED switches from blinking red
to green - red - green steady light,
the T4PM generates an electronic
beeping sound, and "LINK:OK" and
"COMPLETE!" appear on the screen.
Reading of the mutual IDs ends and
the memorized receiver ID num-
ber appears on T4PM screen. If an
"TIME OUT" screen appears, linking
failed. Retry linking. If the transmit-
ter and receiver are linked normally,
set the power switch to the OFF po-
sition and then return it to the PWR
ON position. If the receiver LED lights
green, linking was successful. Now
check servo operation.
*The T4PM and a telemetry type T-FHSS receiver (R334SBS, etc.) mutually memorize the
combined ID linked last at each model memory.
Since the T4PM can memorize only 1 receiver ID at each model memory, multiple T-FHSS
receivers cannot be used with the same model memory. When changing the receiver at the
same model memory, re-link the previously linked receiver.
When using multiple telemetry type T-FHSS receivers, link and combine them with each
T4PM model memory.
However, multiple receivers cannot be linked to multiple model memories.
The telemetry function communications status can be checked at the HOME screen.
R334SBS / R334SBS-E receiver software version
The software version is displayed only on the "T -
FHSS" system (telemetry on the transmitter, when
the receiver power is on).
R334SBS
TIME OUT screen
31