FUTABA T4PM Instruction Manual page 78

2
Execute this function to read the connected servo type and the
data currently set at the servo.
Select the setting item "ACCE" by mov-
ing the(JOG) button up or down,and se-
lect the reading method with (+) or (-)
button.
For wireless, move the cursor to the set-
ting item "W-CH" and select the servo connection channel with
the (+) or (-) button.
-Chann e
-Chann e
Select the setting item "MODE" by moving the(JOG) button up
or down. Select "READ" by (+) or (-) button, and press the (JOG)
button.
-" " blinks on the screen and the servo ID and currently set contents are
read.
- If "
performed normally. Check the T4PM and servo connection and the battery connec-
3
(Writing to S.BUS/S.BUS2)
Execute this function to write the setting data to the servo. See
pages 80~81 for the setting data contents. Select the setting
item "MODE" by moving the (JOG) button up or down. Select
"WRITE" by (+) or (-) button, and press the (JOG) button.
-"
"
-If "
performed normally. Check the T4PM and servo connection and the battery connec-
" "
4
(Initialization)
This function writes the servo setting data set at the factory to
the connected servo. Perform "READ" before performing initial-
ization.
Select the setting item "MODE" by moving the (JOG) button
up or down. Select "RESET" by (+) or (-) button, and press the
(JOG) button.
- "
"
-If "
78
"
"
"
S.BUS Link Function "S.BUS SX"
COM W-LES
"RESET" cannot be