Telemetry Sensor Setting - FUTABA T4PM Instruction Manual

Setting the receiver power supply voltage
(Preparation)
MODE: RX (Page 1)
Select the setting item "RX BATT" by moving the (JOG) but-
ton up or down, and display the receiver power supply voltage
screen by pressing the (JOG) button.
1
(Setting of each item)
Select the setting item "ALRM" by moving the (JOG) button up
or down, and set alarm ON/OFF with the (+) button or (-) but-
ton.
" "
" "
2
(Setting the receiver power supply voltage alarm)
Select the setting item "LIMT" by moving the (JOG) button
up or down, and set the voltage at which the alarm begins to
sound with the (+) button or (-) button.
When finished with the setting, return to the TELEMETRY
screen by pressing the (END) button.
Setting external power supply voltage
(Preparation)
MODE: RX (Page 1)
Select the setting item "EXT VOLT" by moving the (JOG) but-
ton up or down, and display the external power supply voltage
screen by pressing the (JOG) button.
1
(Setting of each item)
Select the setting item "ALRM" by moving the (JOG) button up
or down., and set alarm ON/OFF with the (+) button or (-) but-
ton.
" "
" "
2
(Setting the external power supply voltage alarm)
Select the setting item "LIMT" by moving the (JOG) button
up or down, and set the voltage at which the alarm begins to
sound with the (+) button or (-) button.
When finished with the setting, return to the TELEMETRY
screen by pressing the (END) button.
118

Telemetry Sensor Setting

Telemetry "TELEMETRY"
Alarm ON/OFF
ON, OFF
- Select with the (+) or (-) but-
tons.
Voltage alarm
- Adjust with the (+) and (-) but-
tons.
- Return to the initial value by
pressing the (+) and (-) buttons
simultaneously (approx. 1 sec).
Alarm ON/OFF
ON, OFF
- Select with the (+) or (-) but-
tons.
Voltage alarm
- Adjust with the (+) and (-) but-
tons.
- Return to the initial value by
pressing the (+) and (-) buttons
simultaneously (approx. 1 sec).