FUTABA T4PM Instruction Manual page 75

Fail-safe mode selection
(Preparation)
- Select the channels "MODE" to be set by moving the
(JOG) button up, down, left or right.
1
(Mode selection)
Select the mode by (+) or (-) button.
(Each channel can be individually set.)
2
When finished with the setting, return to the MENU
screen by pressing the (END) button.
When setting fail-safe, set the servo position by the following
method.
Fail-safe function setup
1
(Servo position setup)
When the fail-safe function operates, select the setting item
"POSI" by moving the (JOG) button up or down. The steer-
ing wheel, the throttle trigger or 3rd, 4th channel dial remains
in the desired operation position. When the (JOG) button is
pressed for approximately 1 second, the servo position is dis-
played and you can confi rm that the function was set.
(Each channel can be set similar.)
2
When finished with the setting, return to the MENU screen by
pressing the (END) button.
Battery fail-safe function ON/OFF
(Preparation)
- Select the setting item by moving the (JOG) button up or down.
For Battery F/S function select "OFF" or "ACT" of "B-FS".
For voltage setting, select VOLT. (This applies to the T-FHSS
system only. )
The S-FHSS system is fi xed at 3.8v.
1
(Battery fail-safe function ACT/OFF)
The battery fail-safe function ACT/OFF and volt-
age setting which activates the B-FS function
can be switched by (+) or (-) button.
2
When finished with the setting, return to the MENU screen by
pressing the (END) button.
Fail-safe Function "FAIL SAFE"
FAIL SAFE screen
F/S mode
OFF, HOLD, F/S
F/S mode selection
- Select with the (+) or (-) but-
tons.
F/S position setup button
- The (JOG) button is pressed
for approximately 1 second.
Battery fail-safe function
OFF, ACT
Initial value: OFF
Select button
- Select with the (+) or (-) but-
tons.
B-F/S Voltage
3.8, 4.0, 4.2, 4.4, 4.6, 4.8,
5.0, 5.3, 5.6, 5.9, 6.2, 6.5,
6.8, 7.1, 7.4(V)
Initial value 3.8v
Select button
- Select with the (+) or (-) but-
tons.
Example:
Ni-MH /Ni-Cd 4cell---3.8V
Ni-MH /Ni-Cd 6cell---4.4V
LiFe 2cell---4.8V
Li-Po 2cell---5.6V
75