FUTABA T4PM Instruction Manual page 103

The programmed DT button is used to select the drive type as
shown in the fi gure below.
2
(Rear side travel adjustment)
Select the setting item "RATE" by moving the (JOG) button up
or down. Use when applying a rotation difference to the front
and rear wheels by adjusting the rear (CH4) motor controller
travel with the (+) or (-) button.
3
(Mix mode setting)
Select the setting item "MXMD" by moving the (JOG) button up
or down. Set the mix mode with the (+) or (-) button.
" "
" "
4
(Trim mode setting)
Select the setting item "TRIM" by moving the (JOG) button up
or down. Set the trim mode with the (+) or (-) button.
" "
" "
5
When finished with the setting, return to the MENU screen by
pressing the (END) button.
Dial / Trim Setting
Note:
due to use of this function.
Dual ESC Mixing "DUAL ESC"
Rear rate (RATE)
0 ~ 120
Initial value:100
Adjustment buttons
- Use the (+) and (-) buttons to
make adjustments.
- Return to the initial value by
pressing the (+) and (-) buttons
simultaneously (approx. 1 sec).
Mixing mode (MXMD)
OFF, ON
Initial value: OFF
Select button
- Select with the (+) or (-) but-
tons.
Trim mode (TRIM)
OFF, ON
Initial value: OFF
Select button
- Select with the (+) or (-) but-
tons.
103