FUTABA T4PM Instruction Manual page 59

- DELY : Delay
delay of approximately 2 seconds.
- CYCL : Cycle speed
- TG.P : Trigger point
- DUTY : Cycle duty ratio
Sets the proportion of the time the brakes are applied and the time the brakes are re-
- MODE : Function ON/OFF
A.B.S function adjustment
1
(Function ON/OFF)
Select the setting item "MODE" by moving the (JOG) button up
or down. Set the function to the active state by pressing the (+)
or (-) button.
" "
" "
" "
2
(Brake return amount adjustment)
Select the setting item "AB.P" by
moving the (JOG) button up or
down. Use the (+) or (-) button to
adjust the return amount.
" "
" "
" "
3
(Delay amount setup)
Select the setting item "DELY" by moving the (JOG) button up
or down. Use the (+) or (-) button to adjust the delay amount.
" "
" "
" "
AB.P
AB.P
(Amount of brake return)
A.B.S. Function "TH A.B.S"
" .
"
Select button
- Select with the (+) or (-) but-
tons.
Function ON/OFF (MODE)
INH (OFF), ACT (ON,OFF)
Brake return amount (AB.P)
0 ~ 50 ~ 100
Initial value: 50
- Brake return amount (AB.P) is
influenced by the "EXP" rate
on the brake side.
Adjustment buttons
- Use the (+) and (-) buttons to
make adjustments.
- Return to the initial value by
pressing the (+) and (-) buttons
simultaneously (approx. 1 sec).
Delay amount (DELY)
0 ~ 100
Initial value: 0
Adjustment buttons
- Use the (+) and (-) buttons to
make adjustments.
- Return to the initial value by
pressing the (+) and (-) buttons
simultaneously (approx. 1 sec).
59