FUTABA T4PM Instruction Manual page 73

2
(Select the setting item )
Select "MODE" by moving the (JOG) button up
or down, and select the transfer side and receiv-
ing side using the (+) or (-) button.
" "
" "
3
(Data transfer execution)
Select the setting item "EXEC" by moving the
(JOG) button up or down on both transmitters.
First, press the receiving side "RECV" transmit-
ter (JOG) button. The message "RCV WAIT.."
appears and countdown begins.
Within 30 seconds, press the transfer side
"TRANS" transmitter (JOG) button. (If data
transfer is not executed within
30 seconds, an error will be
displayed at the receiving side
"RECV" transmitter.)
-"COMPLETE!" is displayed
on the screen of the receiving
side "RECV" transmitter and
data transfer is ends.
-If "RCV ERROR!" is displayed on the screen of
the receiving side "RECEIVE" transmitter, data
transfer was not performed normally. Check the
connection and repeat steps 1 3. Since the
transfer side "TRANS" transmitter only sends,
"COMPLETE!" is displayed even when data
transfer was not performed normally.
Data transfer can also be canceled before the
end of transfer by operating the (JOG) button at
a T4PM that is waiting to receive data.
4
When finished with the setting, return to the
MENU screen by pressing the (END) button.
Data Transfer "MDL TRANS"
Mode selection
"TRANSFER" "RECEIVE"
Setup item selection
- Select by (JOG) button up or
down operation.
Mode change button
- Use the (+) and (-) buttons to
make adjustments.
Transfer execution button
- (JOG) button pressed.
*30 seconds wait is displayed
on the receive side screen.
"COMPLELE!" is displayed.
"RCV ERROR!" is displayed.
"CANCEL" is displayed.
73