FUTABA T4PM Instruction Manual page 49

Throttle (END POINT) adjustment
(Preparation)
- Before setting the throttle end point adjustment (END POINT),
set the throttle ATL trim (initial setup: DT5) to the maximum
throttle angle position 100%.
- Select the setting item "FWD" by moving up or down on the (JOG)
button and make the following adjustments: Or move the throttle
trigger fore or aft to select FWD or REV.
1
Throttle (forward side) adjustment
Pull the throttle trigger fully to the high side and
use the (+) or (-) buttons to adjust the throttle
angle. However, when using an electronic motor
speed controller (ESC), set to 100%.
2
Throttle (brake side/reverse side) adjustment
Move the throttle trigger fully to the brake side
and use the (+) or (-) buttons to adjust the throt-
tle angle. However, when using an electronic mo-
tor speed controller (ESC), set to 100%.
3
When finished with the setting, return to the MENU screen by
pressing the (END) button.
3rd & 4th channel servo (END POINT) adjustment
1
3rd/4th channel servo (up side) adjustment
Select the setting item "CH3 or CH4 UP" by moving the (JOG)
button up or down. Set the 3rd or 4th channel dial fully to the
up side (+ side) and use the (+) or (-) buttons to adjust the ser-
vo angle.
2
3rd/4th channel servo (down side) adjustment
Select the setting item "CH3 or CH4 DWN" by moving the (JOG)
button up or down. Set the 3rd or 4th channel dial fully to the
up side (- side) and use the (+) or (-) buttons to adjust the ser-
vo angle.
3
When finished with the setting, return to the MENU screen by
pressing the (END) button.
End Point Adjuster "END POINT"
100
(HOME screen)
Adjustment buttons
- Use the (+) and (-) buttons to
make adjustments.
- Return to the initial value by
pressing the (+) and (-) buttons
simultaneously (approx. 1 sec).
Throttle END POINT
THR FWD: 0~120
THR BRK: 0~120
Initial value: 100
Adjustment buttons
- Use the (+) and (-) buttons to
make adjustments.
- Return to the initial value by
pressing the (+) and (-) buttons
simultaneously (approx. 1 sec).
3rd & 4th channel END POINT
CH3/CH4 UP: 0~120
CH3/CH4 DWN: 0~120
Initial value : 100
49