Speedometer Sensor; Front Brake Caliper; Checking Front Brake Wear - Malaguti Madison3 250ie Workshop Manual

FRAME AND RUNNING GEAR
A
4

SPEEDOMETER SENSOR

• Undo screw (V) ensuring the spacer does not fall.
• Disconnect the electronic transmission connector.
When refitting, use a feeler gauge, to check
that the sensor - disc gap is 1÷2 mm.
• Remove the sensor complete with the transmission.

FRONT BRAKE CALIPER

• Undo the screw of the hydraulic transmission (V) and
remove the hydraulic transmission and its gaskets.
When reassembling, replace the gaskets of
the hydraulic transmission.
V
• Undo screws (V2) and free the complete caliper.
After having removed the hydraulic tran-
smission and the caliper from its seat, pla-
ce a recipient under it to collect the brake
fluid. Dispose of used brake fluid in com-
pliance with statutory legislation.
V
2

CHECKING FRONT BRAKE WEAR

• Take the opportunity to check also wear of the brake
disc. If they are scored or unevenly worn, they can be
reground.
If disc thickness has worn to less than 3.5 mm the
discs must be changed.
Minimum thickness of the pads is 2 mm.
Note For overhauling the caliper, see the specific
Chapter.
DISASSEMBLY
20 ± 10%
30 ± 20%
06039095_2
06039095_2
22 05/06
MADISON 3
250 ie
V
V V
2
2 mm