Timing; Head Cylinder Tightening - Malaguti MALBO Line Service Manual

TIMING

- Position the rotor on the crank shaft, making sure it cor-
rectly fits on the key.
- Turn the magneto flywheel (1) to position the "T" refer-
ence in front of the crankcase stud (2) (clockwise).
- Position the cam shaft pinion references as on the refer-
ence (3).
- Position the timing chain on the cam shaft pinion (5).
- Make sure the cam shaft references (3) are parallel to
the head level (4).
- Position the valve rocker arm bracket.

HEAD CYLINDER TIGHTENING

- This operation is performed in several steps:
- Slightly grease the stud bolts.
- Position the 4 washers.
- Snugly fit the 4 nuts (6) and 2 screws (7).
- Tighten the 4 nuts in crossed order.
Cs - N * m
6
18
- Tighten the 2 screws (7).
Cs - N * m
7
8
58 03/10
Fig. 59
Fig. 60
Fig. 61