Technical Data; Technical Data Of The Sinamics G110D - Siemens SINAMICS G110D Operating Instructions Manual

Technical data

9.1

Technical data of the SINAMICS G110D

Technical data of the SINAMICS G110D
Feature
Line operating voltage
Operating voltage
Input frequency
Power factor λ
Overload capability
Digital inputs
Analog inputs
Setpoint resolution
Pulse frequency
Possible braking meth-
ods
Degree of protection
Operating temperature
Transport/storage tem-
perature
Relative humidity
Installation altitude
Dimensions (WxHxD)
SINAMICS G110D
Operating Instructions, 07/2016, FW V3.63, A5E36768472B AB
Data
3 AC 380 V ... 500 V ± 10%
Supply from the ASi bus or an external 24 V DC supply (20.4 V to 28.8 V,
0.5 A)
47 Hz ... 63 Hz
0.7 ... 0.85
The SINAMICS G110D can either be operated with high overload (HO). In
order to avoid overtemperature of the Power Module, after the overload,
as a minimum its load must decrease back to the base load (HO base
load or LO base load).
HO base load 150% overload for 57 s
0.75 kW ... 7.5 kW 200% overload for 3 s
87% HO base load for 240 s
See note 1.
4; PNP
Low < 5 V, High > 10 V, maximum input voltage 30 V, 5.5 mA
1, with 10-bit resolution
AI0: 0 V to 10 V, unipolar voltage only
Analog input can also be configured as a digital input
0.01 Hz
4 kHz for 0.75 kW ... 7.5 kW (HO)
DC braking, dynamic braking with integrated braking chopper
IP65
0.75 kW ... 7.5 kW (HO)
-10 °C ... +40 °C (14 °F ... 104 °F)
See note 1.
-40 °C ... +70 °C (-40 °F ... 158 °F)
< 95% RH - condensation not permissible
0.75 kW ... 7.5 kW (HO)
Up to 1000 m (3300 ft) above sea level
FSA: 195 mm x 425 mm 125 mm (145 mm with repair switch)
FSB: 195 mm x 425 mm 165 mm (165 mm with repair switch)
FSC: 195 mm x 425 mm 240 mm (240 mm with repair switch)
The permissible line operating voltage
depends on the installation altitude
Higher operating temperatures are
possible when the rated power is
reduced (derating)
Higher altitudes are possible
when the rated power is re-
duced (derating)
9
209