Siemens SINAMICS G110D Operating Instructions Manual page 167

Configuring the properties of an AS-i slave
Using the individual property dialogs an slave can be configured with the following
properties:
● Enter configuration data of the specific AS-i slave.
● Specify the I/O configuration.
● Set the AS-i parameters.
Image 6-31
The AS-i standard slave can only be placed at an AS-i address in the A area. This address is
then no longer available in the B area.
As an option, at start-up parameters can be permitted - whether this parameter can be used
depends on the slave type.
If the AS-i slave does not support the ID1/ID2 codes, the values F (hex) must be entered.
SINAMICS G110D
Operating Instructions, 07/2016, FW V3.63, A5E36768472B AB
Configuring standard AS-i slave
6.11 Operation in fieldbus systems
Functions
167