Technical Data - Festo CPX-E-EP Manual

A

Technical Data

A Technical Data
General
Feature
General technical data, system CPX-E
Dimensions (length x width x height)
1)
Product weight
Mounting position
Ambient temperature
Storage temperature
Air humidity (non-condensing)
Assigned address space (inputs/outputs)
Without diagnostics
With status bits
With I/O diagnostic interface
Module code/submodule code (CPX-E-specific)
Module identification
Degree of protection in accordance with EN 60529
Protection against electric shock (protection against
direct and indirect contact to IEC 60204-1)
Electromagnetic compatibility
1) Including linking
2) With horizontal mounting position
Tab. A.1
Power supply
Feature
Power supply for electronics/sensors (U
Intrinsic current consumption at nominal operating
voltage 24 V from U
EL/SEN
Reverse polarity protection 24 V U
U
EL/SEN
Mains buffering time
Tab. A.2
Network-specific
Feature
Protocol
Specification
Transmission rate
Crossover detection
Maximum cable length per segment
Cable specification
Cable type
Transmission class
Cable diameter
Wire cross section
1) Based on the Ethernet protocol IEEE 802.3
2) At a transmission rate of 100 Mbps
3) Required for maximum connection length between network participants
Tab. A.3
Festo – CPX-E-EP-EN – 2017-07 – English
[mm]
[g]
[°C]
[°C]
[%]
[bit]
[bit]
[bit]
) [V DC]
EL/SEN
[mA]
against 0 V
EL/SEN
[ms]
[Mbps]
[m]
[mm]
[mm²]
Specification/value
Description of system CPX-E
è 1.1 Further applicable documents
125.8 x 37.8 x 76.5
145
Vertical/horizontal
2)
–5 ... +60 (–5 ... +50)
–20 ... +70
0 ... 95
–/–
8/–
16/16
222/36
E-EP
IP20
Through the use of PELV circuits
(Protected extra-low voltage)
To EN 61000-6-2/-4 and NE 21
Specification/value
24 ± 25 %
70
Yes
20
Specification/value
EtherNet/IP and Modbus TCP
EtherNet/IP
10/100 (full duplex/half duplex)
Auto-MDI/MDI-X
2)
100
Ethernet twisted pair cable, screened
Category Cat 5/Cat 5e (link class)
6 ... 8
3)
0.14 ... 0.75; 22 AWG
1)
47