Festo CPX-E-EP Manual page 22

3 Parameterisation
Attribute no. Access
6 Set (NV)
7 Get
8 Get
9 Set (NV)
10 Get
11 Get
12 Get
22
Description
Interface control
Control bits
Bit 0 Autonegotiate
0 = Autonegotiation disabled
1 = Autonegotiation enabled
Bit 1 Forced duplex mode
0 = The interface duplex should be half duplex
1 = The interface duplex should be full duplex
Bit 2 ... 15 Reserved, shall be 0
Forced interface speed (in Mbps)
Interface type
0 = Unknown interface type
1 = The interface is internal to the device
2 = Twisted-pair
3 = Optical fiber
Interface state
0 = Unknown interface state
1 = The interface is enabled and ready to send/receive data
2 = The interface is disabled
3 = The interface is testing
Admin state
1 = Enable
2 = Disable
Interface label
Interface capability
Capability bits
Bit 0 Manual setting requires reset
Bit 1 Autonegotiate
Bit 2 Auto MDIX
Bit 3 Manual speed/duplex
Bit 4 ... 31 Reserved, shall be 0
Speed/duplex options
– Speed/duplex array count
– Speed/duplex array
– Interface speed (in Mbps)
– Interface duplex mode
(0 = half duplex, 1 = full duplex)
HC interface counters (high capacity interface counters)
– HCInOctets
– HCInUcastPkts
– HCInMulticastPkts
– HCInBroadcastPkts
– HCOutOctets
– HCOutUcastPkts
– HCOutMulticastPkts
– HCOutBroadcastPkts
Type
STRUCT of WORD
STRUCT of UINT
USINT
USINT
USINT
SHORT_STRING
STRUCT of DWORD
STRUCT of USINT
ARRAY of
STRUCT of
– UINT
– USINT
STRUCT of ULINT
Festo – CPX-E-EP-EN – 2017-07 – English