Festo CPX-M-FB20 Manual page 40

1. Installation
1-26
5. Push the ends of the cable cores into the appropriate
openings on the splice ring (see Fig. 1/8, diagram C).
The numbers printed on the cable correspond to the
numbering on the splice ring.
6. Pull hard on the ends of the cores.
7. Cut off the projecting ends of the cores. Make sure that
the ends of the cores are flush with the splice ring, do not
project, and are not too short (see Fig. 1/8, diagram D).
8. Insert the ready-to-use cable into the appropriate connec-
tion on the Rugged Line plug (see Fig. 1/8, diagram E).
9. Turn the ready-to-use cable until the coding lugs of the
splice ring fit exactly into the appropriate guides of the
Rugged Line plug.
10. Tighten the Quickon screw with the fibre cutter
(see Fig. 1/8, diagram F). The insulation will then be cut
and the electrical contact restored.
Note
If you wish to connect the cable cores again, you must cut
them again, as otherwise the electrical contact cannot be
guaranteed.
Festo P.BE-CPX-FB20/21-EN en 1202a