Festo CPX-M-FB20 Manual page 39

1. Installation
1.5.1 Connecting the power supply U
Festo P.BE-CPX-FB20/21-EN en 1202a
S1
These fitting instructions apply to the fibre optical Rugged
Line plug from Phoenix Contact.
Note
Use a power supply cable 5 x 1.5 mm
Contact (see Appendix A, Tab. A/5). The numbers printed
on this cable correspond to the numbering on the splice
ring of the Rugged Line plug.
Proceed as follows:
1. Break through the sealing rubber with a screwdriver.
2. Push the Quickon screw, the clamping box and the sealing
rubber over the power supply cable (see Fig. 1/8
diagram A).
3. Remove the insulation coating over a length of approx.
10 cm.
4. Push first the sealing rubber to the edge of the insulation,
then push the clamping box onto the sealing rubber
(see Fig. 1/8, diagram B). This forms the strain relief for
the cable.
/U
S2
2
, e.g. from Phoenix
1-25