Connecting The Sensors - Festo CP-E16...M Series Manual

1. Input modules type CP−E16...−M...−...

1.3.3 Connecting the sensors

Festo P.BE−CPEA−EN en 0802e
Caution
If you are using input module type CP−E16−M8−Z, make
sure that pin 2 of the sensor supply connection is bridged
in accordance with the operating method of your system
(either PNP or NPN operation, see section 1.3.1).
Use the following cables or plugs for connecting the sensors:
Type
CP−E16...−M12x2
CP−E16−M12x2−5POL
CP−E16...−M8
and
CP−E16−M8−Z
Fasten the plugs with the aid of the union nut in order to pre
vent unintentional loosening, e.g. due to shock. Seal the un
used sensor connections with the protective caps supplied.
Only in this way can you comply with protection class IP 65.
Plugs
SEA−GS−7 (PG7)
SEA−WS−7 (PG7)
Use plugs with union nuts
with M12x1 thread.
Use plugs with union nuts
with M8x1 thread (outer
diameter max. 12 mm).
Cable
KM12−DUO−...
KM8−M8−GSGD−...
1−15