Instructions On Commissioning - Festo CP-E16...M Series Manual

2. Input module type CP−E16−KL−IP20−Z
2.4

Instructions on commissioning

Status LED
Festo P.BE−CPEA−EN en 0802e
Warning
Please be careful if the string assignment is modified at a
later stage. After saving the string assignment/hardware
configuration, check the address assignments of your
higher−order system before starting user programs.
You can thereby avoid:
addressing errors with unintentionally incorrectly fitted
CP modules.
If, in the case of CP field bus nodes and CP valve terminals
with direct connection, the string assignment is modified (CP
modules added or removed), the new string assignment must
be saved or configured.
Depending on the design of the node or CP valve terminal,
this is accomplished as follows:
press the SAVE button or
configure with the DIL switch.
Proceed here as described in the manual CP system, installa
tion and commissioning" or in the manual for your CP valve
terminal with direct connection".
When the string assignment has been modified on the
SPC200, the new hardware configuration must also be saved.
Proceed here as described in the manual for the SPC200 or in
the WinPISA manual.
The operating status of the input module is indicated by the
status LED on the CP connection (see table below).
2−25