Designated Use - Festo CP-E16...M Series Manual

Contents and general instructions

Designated use

Festo P.BE−CPEA−EN en 0802e
The CP modules described in this manual are intended ex
clusively for use on a CP string, an axis interface string or a
CP branch line in conjunction with a CP field bus node, the
Smart Positioning Controller type SPC200 or the Powerbox
type CP−FB−TBOX−SUBD9. CP modules and CP cables are only
to be used as follows:
in accordance with designated use
in its/their original state
without any modifications by the user
in faultless technical condition.
When used together with commercially available compo
nents, such as sensors and actuators, the specified limits for
pressures, temperatures, electrical data, torques etc. must be
observed. National and local safety regulations must also be
observed. All CP modules comply with protection class III.
Warning
S Use only PELV circuits as per IEC/DIN EN 60204−1 (Pro
tective Extra−Low Voltage, PELV) for the electrical supply.
Consider also the general requirements for PELV circuits
in accordance with IEC/DIN EN 60204−1.
S Use power supplies which guarantee reliable electrical
isolation of the operating voltage as per IEC/DIN EN
60204−1.
V