Easy Setup Overview - Panasonic Aquarea PAW-HPM1 Installation And Commissioning Manual

3

Easy Setup Overview

!
Important notice
This chapter is exclusively intended for qualified technicians with the necessary experience in
dealing with the HPM controller. It contains only the most important commissioning steps and
settings to enable the experienced installers rapid commissioning. It should not be addressed
without reference to the following chapters, since they contain important notes about the
commissioning process and for selecting the optimal parameter values.
Information for using the overview
The following table summarizes the key steps and settings for easy setup of the HPM controller.
For each step, references to the detailed descriptions are provided in the following chapters or
in the "HPM Manual Part 2: Parameter Description".
1
Step 1
Determining system diagram and terminal assignment in the HPMtool
1-1
1-2
1-3
→ Selecting the System Diagram in HPMtool, P. 65
2
Step 2
Install controller and wire according to terminal assignment
2-1
2-2
→ Installation and Terminal Assignments, P. 46
3
Step 3
Enter system diagram and prepare easy setup
3-1
3-2
3-3
→ Loading the system diagram in the HPM controller, P. 68
Aquarea Heat Pump Manager (HPM) – Manual Part 1: Installation and Commissioning – 12/2014
Select system diagram
Determine SD-No.
Print or save terminal assignment
Installing the HPM controller
Perform wiring according to terminal connection diagram
Enter SD no. for system diagram in the HPM controller
Activate Easy setup (easySetup= 1)
Adjust parameter values as required
Easy Setup Overview
Remark
www.hpmtool.eu
→
Remark
Remark
as described in steps 4 to 7
3
15