Panasonic Aquarea PAW-HPM1 Installation And Commissioning Manual page 22

Easy Setup Overview
9
3
22
Continue Step 9
Perform settings for "Add. heat source + buffer tank" (if available)
Name
9-21 addHS-Fl
9-22 addHS
9-23 tDiffOn
9-24 tDiffOff
9-25 maxTaddHS
9-26 addHSFrLim
→ Additional heat source buffer/fireplace, P. 83
Perform settings for "Photovoltaics" (if available)
Name
9-27 type-Pv
if 9-27 type-Pv = 1 (activation via release contact):
9-27.1 rel-pv
if 9-27 type-Pv = 2 (activation via permanently set excess power):
9-27.2 EMngPv
9-27.3 ^Imp/kWh
9-27.4 EMngBuild
9-27.5 ^Imp/kWh
9-27.6 minDiffCap
9-27.7 minSwOfTm Minimum off time of heat pump 10.0 min
if 9-27 type-Pv = 3 (activation via dynamic excess power):
9-27.8 EMngPv
9-27.9 ^Imp/kWh
9-27.10 EMngBuild
9-27.11 ^Imp/kWh
9-27.12 minSwOfTm Minimum off time of heat pump 10.0 min
Aquarea Heat Pump Manager (HPM) – Manual Part 1: Installation and Commissioning – 12/2014
Information text
FlowTemp. addHS
Add. heat source
Temp. difference additional
heat source on
Temp. difference additional
heat source Off
max. Temperature additional
heat source
Frost limit
Information text
1: Contact 2: output
3: Dyn. output
Release contact
Electric photovoltaic energy
Scaling EMngPV
Building electric energy
Scaling EMngBuild
Minimum output difference
Electric photovoltaic energy
Scaling EMngPV
Building electric energy
Scaling EMngBuild
Standard Remark
setpoint
0 Assign available input terminal (17 -
24) e.g. terminal 24;
0 assign available output terminal: e.g.
terminal 9
8.0 K
2.0 K
90.0 °C
–10.0 °C
Standard Remark
setpoint
1 Activation via the release contact (1)
or set excess power (2) or dynamic
excess power (3)
0 Assign terminal: e.g. Terminal 25
0 Assign terminal: e.g. Terminal 25
1 Set pulse value
0 Assign terminal: e.g. Terminal 26
1 Set pulse value
2.0 kW
0 Assign terminal: e.g. Terminal 25
1 Set pulse value
0 Assign terminal: e.g. Terminal 26
1 Set pulse value
(Continue on next page)