Manual Configuration - Panasonic Aquarea PAW-HPM1 Installation And Commissioning Manual

► Using the
► Confirm using the
► Using the
► Using the
► Watch the display until the prompt to enter the display language appears.
 
The further procedure is identical to the steps in the section → Initial loading, P. 70.

8.2.5 Manual Configuration

Should no system diagram be found in the HPMtool that corresponds with the heating system
or similar, entering the SD number 99999 can be used for the manual configuration of the HPM
controller. This SD number is not allocated to a system diagram with predefined parameter
configuration.
Compared to the loading of a system diagram, this method is time-consuming, complex and
error prone and is therefore not recommended for commissioning.
Procedure for reloading and manual configuration
Open the "System diagrams" menu
► Starting from the basic display: Keep pressing the
► Using the
► Confirm setting using the
► Press the
► Press the
► Using the
► Confirm setting using the
 
Aquarea Heat Pump Manager (HPM) – Manual Part 1: Installation and Commissioning – 12/2014
[+] [–]
buttons, enter the SD number 00000
and
[OK]
button.
[▼]
button, select the cold start parameter.
[+]
button, set the parameter to 1 and confirm with the
The delivery state of the HPM controller is restored. The controller is ready for
initial loading of the system diagram.
to enter the access code is shown.
[+] [–]
buttons, enter access code 4444.
and
The display changes to the basic display.
[OK]
button.
The display switches to the MCR-BMS menu.
[▲]
button to get to the main menu.
[▼]
button, select the System diagrams menu.
sysDiagram (system diagram) is marked.
[OK]
[OK]
button.
[OK]
button.
Commissioning
[OK]
button.
button until the prompt
8
89