Sinamics V70 Parameters; Overview - Siemens SINUMERIK 808D ADVANCED Operating Instructions Manual

SINAMICS V70 parameters

6.1

Overview

The chapter below lists the parameters displayed on the BOP only. For more parameters
about the servo drive, refer to SINUMERIK 808D ADVANCED HMI through the following key
operations:
All parameters beginning with "p" are editable parameters, for example, p29000.
All parameters beginning with "r" are read-only parameters, for example, r0018.
Effective
Indicates the conditions for making parameterization effective. Two conditions are possible:
•
IM (Immediately): Parameter value becomes effective immediately after changing.
•
RE (Reset): Parameter value becomes effective after repower-on.
Can be changed
Indicates the state in which the parameter is changeable. Two states are possible:
•
U (Run): Can be changed in the "Running" state. The "RDY" LED indicator lights up green.
•
T (Ready to run): Can be changed in the "Ready" state. The "RDY" LED indicator lights up
red.
Data type
I16
I32
U16
U32
Uint16
Uint32
Float
Parameter Manual
Siemens Controls
Operating Instructions, 08/2013, 6FC5397-8EP40-0BA0
+ →
Type
→ →
16-bit integer
32-bit integer
16 bits without sign
32 bits without sign
16-bit unsigned integer
32-bit unsigned integer
32-bit floating point number
6
Description
459