Siemens SINUMERIK 808D ADVANCED Operating Instructions Manual page 367

Signal state 1
Note for the reader
DB3300
DBX1.0
Edge evaluation: Yes
Signal state 1 or edge
change 0 → 1
Signal state 0 or edge
change 1 → 0
Signal irrelevant for ...
corresponding to ...
Note for the reader
DB3300
DBX1.2
Edge evaluation: No
Signal state 1
corresponding to ...
Note for the reader
DB3300
DBX1.3
Edge evaluation: No
Signal state 1
Siemens Controls
Parameter Manual
Operating Instructions, 08/2013, 6FC5397-8EP40-0BA0
Block search: Last block of the output with collected auxiliary functions.
Function Manual Basic Functions K1
Referencing active
Signal(s) from channel (NCK → PLC)
Signal(s) updated: Cyclic
The channel-specific referencing was started using the IS: "Activate
referencing" and the successful start was acknowledged using IS
"Referencing active". The channel-specific referencing is running.
•
Channel-specific referencing has been completed
•
Axis-specific referencing is running
• No referencing active
Spindles
IS "Activate referencing" (DB3200 DBX1.0)
Function Manual Basic Functions R1
Revolutional feedrate active
Signal(s) from channel (NCK → PLC)
Signal(s) updated: Cyclic
When programming of G95 (revolutional feedrate) in the JOG or automatic
mode.
SD41100 JOG_REV_IS_ACTIVE (JOG: Revolutional / linear feedrate)
SD42600 JOG_FEED_PER_REV_SOURCE
(control revolutional feedrate in JOG)
SD43300 ASSIGN_FEED_PER_REV_SOURCE
(revolutional feedrate for positioning axes / spindles)
MD32040 JOG_REV_VELO_RAPID (revolutional feedrate for JOG with
rapid traverse override)
MD32050 JOG_REV_VELO (revolutional feedrate for JOG)
Function Manual Basic Functions V1
Handwheel override active
Signal(s) from channel (NCK → PLC)
Signal(s) updated: Cyclic
The function "Handwheel override in AUTOMATIC mode" is active for the
programmed path axes.
Handwheel pulses of the 1st geometry axis function as a velocity override
over the programmed path feedrate.
Detailed descriptions of interface signals
4.7 Channel-specific signals
367