Siemens SINUMERIK 808D ADVANCED Operating Instructions Manual page 325

43206 SPIND_SPEED_TYPE
- Spindle speed type for spindle start through VDI
-
- -
Definition of the spindle speed type for the master spindle.
Description:
The range of values and the functionality correspond to the 15th G group
"feed type".
Permissible values are the G values: 93, 94, 95, 96, 961, 97, 971 and 973.
The stated values make a functional distinction between the following vari-
ants:
==>
$SA_SPIND_S.
==>
of SD 43202 $SA_SPIND_CONSTCUT_S and the radius of the transverse axis.
==>
active
The default value is 94 (corresponds to G94)
The default value becomes active if the SD is written with impermissible val-
ues.
43210 SPIND_MIN_VELO_G25
rev/min Programmed spindle speed limitation G25
-
- -
A minimum spindle speed limit below which the spindle must not fall is
Description:
entered in SPIND_MIN_VELO_G25. The NCK limits the set spindle speed to this
value if it is too low.
The spindle speed may only fall below the minimum as a result of:
•
•
•
•
•
•
•
•
•
SD irrelevant to ......
other spindle modes used in open-loop control mode (SPOS, M19, SPOSA)
Related to:
Siemens Controls
Parameter Manual
Operating Instructions, 08/2013, 6FC5397-8EP40-0BA0
94
93, 94, 95, 97 and 971: The spindle is started at the speed in SD 43200
96 and 961: The speed of the spindle is derived from the cutting speed
973: G973 behaves like G97, but the spindle speed limitation is not
0.0
Spindle offset 0%
M5
S0
NC/PLC interface signal DB380x DBX4.3 (Spindle stop)
NC/PLC interface signal DB380x DBX2.1 (Servo enable)
NC/PLC interface signal DB3300 DBX3.7 (Channel status: Reset)
NC/PLC interface signal DB380x DBX2.2 (Delete distance-to-go/Spindle
reset)
NC/PLC interface signal DB380x DBX2002.5 (Oscillation speed)
Cancel S value
MD10709 $MN_PROG_SD_POWERON_INIT_TAB
MD10710 $MN_PROG_SD_RESET_SAVE_TAB
A06
DWORD
93 973
-
DOUBLE
0.0 -
NC setting data
-
Immediately
7/7
S1
Immediately
7/7
325