Siemens SINUMERIK 808D ADVANCED Operating Instructions Manual page 75

12040 OVR_RAPID_IS_GRAY_CODE
- Rapid traverse override switch Gray-coded
-
- -
This machine data is used to adapt the rapid traverse override switch to the
Description:
interface coding of the PLC interface.
1:
verse override A-H) are interpreted as a Gray code. The value which is read
corresponds to a switch setting.
It is used as an index for selecting the correct override factor from the
table of MD12050 $MN_OVR_FACTOR_RAPID_TRA[n].
0:
a binary representation of the override value in percent (limit 200 percent).
Related to:
NC/PLC interface signal DB3200 DBX5 (Rapid traverse override A-H)
MD12050 $MN_OVR_FACTOR_RAPID_TRA[n]
(Evaluation of the rapid traverse override switch)
12050 OVR_FACTOR_RAPID_TRA
- Evaluation of rapid traverse override switch
-
- 31
Evaluation of the rapid traverse override switch with gray-coded interface.
Description:
Not relevant with:
MD12040 $MN_OVR_RAPID_IS_GRAY_CODE = 0
Related to:
NC/PLC interface signal DB3200 DBX5 (Rapid traverse override A-H)
12060 OVR_SPIND_IS_GRAY_CODE
- Spindle override switch Gray-coded
-
- -
This machine data is used to adapt the spindle speed override switch to the
Description:
interface coding of the PLC interface.
1:
nal are interpreted as a Gray code. The value which is read corresponds to a
switch setting. It is used as an index for selecting the correct override
factor from the table of MD12070 $MN_OVR_FACTOR_SPIND_ SPEED [n].
0:
binary representation of the override value in percent (limit 200 percent).
Related to:
NC/PLC interface signal DB380x DBX2003 (Spindle speed override)
MD12070 $MN_OVR_FACTOR_SPIND_SPEED[n]
(Evaluation of the spindle speed override switch)
Siemens Controls
Parameter Manual
Operating Instructions, 08/2013, 6FC5397-8EP40-0BA0
TRUE
The 5 low-order bits of the PLC interface signal DB3200 DBX5 (Rapid tra-
The rapid traverse override byte of the PLC interface is interpreted as
0.00, 0.01, 0.02, 0.04,
0.06, 0.08, 0.10...
TRUE
The 5 low-order bits of the "spindle speed override" PLC interface sig-
The spindle speed override byte of the PLC interface is interpreted as a
EXP, N10
BOOLEAN
0 -
EXP, N10
DOUBLE
0.00 1.00
EXP, N10
BOOLEAN
0 -
Machine data
2.2 General machine data
V1,Z1
PowerOn
1/1
V1,Z1
PowerOn
1/1
V1,Z1
PowerOn
1/1
75