Siemens SINUMERIK 808D ADVANCED Operating Instructions Manual page 78

Machine data
2.2 General machine data
13114 PROFIBUS_TRACE_START_EVENT
- Trigger conditions for PROFIBUS/PROFINET trace
-
808d-me42 14
808d-me62 14
808d-te42 14
808d-te62 14
For PROFIBUS/PROFINET only:
Description:
The trigger frequency is configured bit-by-bit
Bits
Bits 16-23: 0x01-0x14: process data number (a maximum of 20 words are permis-
sible)
Bits 24-27:0x01: status change 0->1
Bits 28-31:0x10: send slot
When MD13113 $MN_PROFIBUS_TRACE_START=1 and MD13114
$MN_PROFIBUS_TRACE_START_EVENT=0x0 Recording starts immediately
When MD13113 $MN_PROFIBUS_TRACE_START=1 and MD13114
$MN_PROFIBUS_TRACE_START_EVENT=0x1 Recording starts on control power on
When MD13113 $MN_PROFIBUS_TRACE_START=1 and MD13114
$MN_PROFIBUS_TRACE_START_EVENT=0x2 Recording starts on loss of the sign of
life
13200 MEAS_PROBE_LOW_ACTIVE
- Polarity reversal of sensor
-
- 2
This MD defines the electrical polarity of each connected sensor.
Description:
Value 0:
(Default setting)
Non-deflected state
Deflected state
Value 1:
Non-deflected state
Deflected state
The programmed edges of the sensor are independent of the electrical polar-
ity, and are to be regarded as purely mechanical. The programming of a posi-
tive edge always means the transition from the non-deflected into the
deflected state. The programming of a negative edge always means the transi-
tion from the deflected into the non-deflected state.
78
0, 0, 0, 0, 0, 0, 0, 0...
0, 0, 0, 0, 0, 0, 0, 0...
0, 0, 0, 0, 0, 0, 0, 0...
0, 0, 0, 0, 0, 0, 0, 0...
0-15: 0x0001-0xffff: bit mask
0x00: status change 1->0
0x00: receive slot
FALSE, FALSE
EXP
DWORD
0x00000000 0x111fffff
0x00000000 0x111fffff
0x00000000 0x111fffff
0x00000000 0x111fffff
N10, N09
BOOLEAN
0 -
0 V
24 V
24 V
0 V
Operating Instructions, 08/2013, 6FC5397-8EP40-0BA0
-
NEW CONF
0/0
1/1
0/0
1/1
M5
PowerOn
3/3
Parameter Manual