General Signals From Nck - Siemens SINUMERIK 808D ADVANCED Operating Instructions Manual

corresponding to ...
Note for the reader
4.5.2

General signals from NCK

DB2700
DBX0.1
Edge evaluation: No
Signal state 1 or edge
change 0 → 1
corresponding to ...
DB2700
DBX1.0 and .1
Edge evaluation: No
Signal state 1 or edge
change 0 → 1
Signal state 0 or edge
change 1 → 0
Note for the reader
DB2700
DBX1.7
Edge evaluation: No
Signal state 1
Signal state 0
Note for the reader
DB2700
DBX2.3
Edge evaluation: No
Signal state 1 or edge
change 0 → 1
Signal state 0 or edge
change 1 → 0
Note for the reader
Siemens Controls
Parameter Manual
Operating Instructions, 08/2013, 6FC5397-8EP40-0BA0
IS "Machine function 1 INC up to continuous" in the mode area (DB3000
DBX2.0 to .6)
IS "Machine function 1 INC, ..., continuous"
for axis 1 in the Work (DB3200 DBX1001.0 to .6)
for axis 2 in the Work (DB3200 DBX1005.0 to .6)
for axis 3 in the Work (DB3200 DBX1009.0 to .6)
IS "Machine function 1 INC, ..., continuous" in the axis area (DB380x
DBX5.0 to .6)
Function Manual Basic Functions H2
EMERGENCY OFF active
Signal(s) from NC (NCK → PLC)
Signal(s) updated: Cyclic
The NC is in the EMERGENCY OFF state.
IS "EMERGENCY OFF" (DB2600 DBX0.1)
IS "Acknowledge EMERGENCY OFF" (DB2600 DBX0.2)
Probe actuated
Signal(s) from NC (NCK → PLC)
Signal(s) updated: Cyclic
Probe 1 or 2 is actuated.
Probe 1 or 2 is not actuated.
Function Manual Basic Functions M5
Inch measuring system
Signal(s) from NC (NCK → PLC)
Signal(s) updated: Cyclic
The NC operates with the inch measuring system.
The NC operates with the metric measuring system.
Function Manual Basic Functions G2
HMI ready
Signal(s) from NC (NCK → PLC)
Signal(s) updated: Cyclic
The CPU is ready and registers itself cyclically with the NCK.
The CPU is not ready.
Function Manual Basic Functions G2
Detailed descriptions of interface signals
4.5 NCK signals
343