Siemens SINUMERIK 808D ADVANCED Operating Instructions Manual page 45

10718 M_NO_FCT_CYCLE_PAR
- M function replacement with parameters
-
- -
If an M function replacement was configured with MD10715
Description:
$MN_M_NO_FCT_CYCLE[n] / MD10716 $MN_M_NO_FCT_CYCLE_NAME[n], a parameter
transfer via system variable can be specified for one of these M functions
using MD10718 $MN_M_NO_FCT_CYCLE_PAR, in the same way as T function replace-
ment. The parameters stored in the system variables always refer to the part
program line where the M function to be replaced was programmed.
The following system variables are available:
$C_ME
$C_T_PROG
$C_T
$C_TE
$C_TS_PROG : TRUE if address TS was programmed
$C_TS
$C_D_PROG
$C_D
$C_DL_PROG : TRUE if address DL was programmed
$C_DL
10719 T_NO_FCT_CYCLE_MODE
- Setting of T function substitution
-
- -
Description: This machine data parameterizes the execution of the replacement subprogram
for the tool and tool offset selection.
Bit 0 = 0:
D or DL number is transferred to the replacement subprogram (default value)
Bit 0 = 1:
The D or DL number is not transferred to the replacement subprogram if the
following conditions are fulfilled: MD22550 $MC_TOOL_CHANGE_MODE = 1
gramming D/DL with T or M function with which the tool change cycle is
called, in a part program line.
Bit 1 = 0
Execution of the replacement subprogram at end of block (default value)
Bit 1 = 1
Execution of the replacement subprogram at block start
Bit 2 = 0:
Execution of the replacement subprogram according to the settin of bit 1
Bit 2 = 1:
Execution of the replacement subprogram at block start and at end of block.
Siemens Controls
Parameter Manual
Operating Instructions, 08/2013, 6FC5397-8EP40-0BA0
-1 -
: Address extension of the replaced M function
: TRUE if address T was programmed
: Value of address T ( Integer )
: Address extension of address T
: Value of address TS (string, only with tool management )
: TRUE if address D was programmed
: Value of address D
: Value of address DL
0 0
2.2 General machine data
EXP, N12, N07 K1
DWORD PowerOn
- 2/2
EXP, N12, N07 K1
DWORD PowerOn
7 2/2
Machine data
Pro-
45