System; Compute Module - NEC MultiSync UN462A User Manual

OPTION MENU
SLOT2 CH SELECT
DisplayPort
TMDS
RESET

SYSTEM

SYSTEM MENU
MONITOR INFORMATION
FIRMWARE
MAC ADDRESS
FACTORY RESET

COMPUTE MODULE

When a Raspberry Pi Compute Module Interface Board and Raspberry Pi Compute Module are installed, additional OSD menu items will be
available for configuring the related settings. Please do not change settings in COMPUTE MODULE yourself. See
C MODULE MENU
POWER
POWER SUPPLY
AUTO POWER ON
SERVICE MENU
SETTING LOCK
USB BOOT MODE
IR SIGNAL
MONITOR CONTROL
SHUTDOWN SIGNAL
POWER SUPPLY
OFF DELAY
WDT
START UP TIME
PERIOD TIME
CHANGE PASSWORD
This function is available only when [SLOT2 CH SETTING] is [1CH].
Shows the DisplayPort signal from a slot 2 type PC option on the full screen.
Shows the [TMDS] signal from a slot 2 type PC option on the full screen.
Resets the [AUDIO] setting back to the factory setting within the OPTION menu.
Shows the model name, serial number and firmware version of your monitor.
[CARBON SAVINGS]: Display the estimated carbon saving information in kg-CO2. The carbon footprint factor
in the carbon saving calculation is based on the OECD (2008 Edition).
[CARBON USAGE]: Display the estimated carbon usage information in kg-CO2. This is the arithmetic
estimation, not actual measurement value. This estimation is based without any options.
Displays firmware version that is installed to the monitor.
Displays the [MAC ADDRESS].
All items are returned to factory shipment state.
NOTE: You can reset all items in all daisy chained monitors. Please be careful to avoid resetting all items
inadvertently.
Controls power to the Compute Module.
When set to Enable, power to the Compute Module will be turned on automatically when the display power is
turned on.
Locks all settings under [COMPUTE MODULE].
When set to Enable, the Compute Module will appear as a USB device to a PC connected to the USB2 input
on the display and can be programmed with an Operating System. When set to Disable, the Compute Module
will boot normally.
Enables or disables the forwarding of IR remote control signals.
Enables or disables the internal serial connection between the display and Compute Module.
Enables or disables the use of GPIO 23 to signal that power to the compute module will be shutting down.
This sets the time delay after the Shutdown Signal is set until the power to the Compute Module is turned off.
Configure this to allow adequate time for any software to shutdown safely.
Enables or Disables the display's built in Watchdog Timer function for the Compute Module.
This sets the time delay for when the display should start receiving WDT reset commands.
This sets the maximum amount of time within which the display must receive WDT reset commands from the

Compute Module.

English−122
page 100.