Display Protection - NEC MultiSync UN462A User Manual

DISPLAY PROTECTION

PROTECT MENU
POWER SAVE
AUTO POWER SAVE
TIME SETTING
POWER SAVE MESSAGE
FAN CONTROL
HEAT STATUS
SCREEN SAVER
GAMMA
*2
BACKLIGHT
*2
MOTION *3
SIDE BORDER COLOR
POWER ON DELAY
DELAY TIME
LINK TO ID
ALERT MAIL
INTELLI. WIRELESS DATA
RESET
* : The function is available only when connecting the optional control unit.
1
* : If [SPECTRAVIEW ENGINE] is [ON], this function is grayed out.
2
* : When you select [OPTION] for signal input, this function depends on which Option Board installed in the monitor.
3
Set [ENABLE] or [DISABLE]. If you set it to [ENABLE], set how long the monitor waits to go into power save
mode after signal is lost. For more details please check the Power Indicator (see


NOTE: • The display card might not stop sending the digital data even though the image might have
disappeared. If this occurs the monitor will not switch into power management mode.

•
[POWER SAVE] is disabled when [AUTO OFF] or [CUSTOM] is selected in [HUMAN SENSING]
Set the time when the monitor goes into auto power save mode after signal is lost.
When a cable is connected to the HDMI OUT port, this function is not available.
When the monitor goes into power save mode, a message is displayed when [ON] is selected.
Cooling fans will reduce the internal temperature of the monitor to protect it from overheating.
If [AUTO] is selected, you can adjust the start temperature of the cooling fans and the fan speed.
Shows the actual status of the fans, backlight and temperature sensors.
Use the [SCREEN SAVER] function to reduce the risk of Image Persistence.


NOTE: • When the screen saver is activated, the image will be changed to [FULL] image. After the screen
saver stops, the image will be reproduced again with the current [ASPECT] setting.

•
When the [SCREEN SAVER] is set to active, [MULTI PICTURE MODE], [STILL], [IMAGE FLIP]
(except for NONE) or [TEXT TICKER], [POINT ZOOM], [TILE MATRIX], [CLOSED CAPTION] are
not available.

•
The [SCREEN SAVER] cannot be selected for 3840 x 2160 at 60 Hz signal input.
The monitor gamma is switches to the gamma which prevents image persistence when [ON] is selected.
The brightness of the backlight is decreased when [ON] is selected.
NOTE: Do not select this function when [ROOM LIGHT SENSING] is set to [MODE1] or [MODE2].
The screen image is slightly expanded and moves in 4 directions (UP, DOWN, RIGHT, LEFT) at user
determined intervals. You can set interval time and zoom ratio.


NOTE: • If the [HDMI] in the [TERMINAL SETTINGS] is set to [MODE 2], this function is not available.
Adjusts the color of the side borders when a 4:3 image is reproduced.
By pressing the + button on the remote control, the side borders will become brighter.
By pressing the - button, the side borders will become darker.
Background color of the Media Player window is also changed.
Adjusts the delay time between being in standby mode and entering power on mode.
[POWER ON DELAY] can be set between 0 and 50 seconds.
When [ON] is selected, the delay time is linked with the Monitor ID. It takes more time when there are a large
number of IDs.
Set [ON] to activate alert mail. See
Select [ON] to activate [INTELLIGENT WIRELESS DATA] function (see
when using this function.
Resets all settings within the DISPLAY PROTECTION menu back to factory setting except for [POWER ON
DELAY] and [INTELLI.WIRELESS DATA].
page 85.
English−116
page 93).
page 88). A password is required
.
*1