NEC MultiSync UN462A User Manual page 124

CONTROL MENU
HUMAN SENSING *2
DISABLE
AUTO OFF
CUSTOM
POWER INDICATOR
POWER INDICATOR
SCHEDULE INDICATOR
NETWORK FUNCTIONS
USB
TOUCH POWER
(Not available)
EXTERNAL CONTROL
PC SOURCE
USB POWER
* 2 : The function is available only when connecting the optional sensor unit.
[HUMAN SENSING] has three settings.
NOTE: [POWER SAVE] is disabled when [AUTO OFF] or [CUSTOM] is selected in [HUMAN SENSING].
[HUMAN SENSING] is released if [INPUT DETECT] is set while [HUMAN SENSING] is active.
No human sensing.
At the preset time, when no person is detected, [BACKLIGHT] and [VOLUME] automatically go into [OFF].
When a person comes near the monitor again, the monitor will automatically return to normal mode.
[BACKLIGHT] and [VOLUME] automatically shift to the set value when detecting no person. When a person
comes near the monitor again, the monitor automatically returns to normal mode and reproduces the input
signal selected in [INPUT SELECT].
Turns the LED on or off. If [OFF] is selected, the LED will not glow when the monitor is in active mode.
Turns the LED on or off depending on a schedule activity which is set at [SCHEDULE SETTINGS]. If [OFF] is
selected, the LED will not glow even if a schedule is in active mode.
Individually enable or disable the networking component for these monitor functions:
DISPLAY: Enables or disables the network function for controlling the monitor remotely.
When disabled, these functions do not work: External Control, Mail, Daisy chain
functions, HTTP server, SNMP, Crestron, AMX, PJLink.
NOTE: If you disable DISPLAY, monitor control in a daisy chain configuration is not
available. Please be aware of the impact in multi-monitor installations before
disabling it.
COMPUTE MODULE: Enables or disables the network function for the Compute Module Interface Board
only.
MEDIA PLAYER: Enables or disables the network function for the Media Player only.
When disabled, these functions do not work: [SHARED FOLDER SETTINGS] and
[SHARED SD CARD SETTINGS].
Under APPLY, Highlight YES then press SET/POINT ZOOM button to save your
selection. If you do not press SET/POINT ZOOM button when [YES] is highlighted,
your selections are not saved.
NOTE: To apply a firmware version update over the network, [DISPLAY] and [MEDIA
PLAYER] must be enabled.
When [ON] is set, the monitor is controlled by a device installed particular software which is connected to
USB2 port.
Select a device connected to USB1 (SENSOR) port which controls the monitor. If a control device is specific,
select [EXTERNAL PC] or [OPTION].
[OPTION] is only available when slot 2 type PC option is connected to the monitor.
Selects a power relation of USB CM1 (2A).
Set [ON] to supply the power to the USB CM1 (2A).
NOTE: Power consumption depends on which USB devices are connected to the monitor.
English−120