System - NEC MultiSync ME501 User Manual

SYSTEM

SYSTEM MENU
MONITOR INFORMATION
FIRMWARE
MAC ADDRESS
DATE & TIME
YEAR
MONTH
DAY
TIME
CURRENT DATE TIME
DAYLIGHT SAVING
DAYLIGHT SAVING
BEGIN MONTH
END MONTH
TIME DIFFERENCE
EXTERNAL CONTROL
MONITOR ID
GROUP ID
CONTROL TERMINAL
LANGUAGE
Shows the model name, serial number and firmware version of the monitor.
[CARBON SAVINGS]: Shows the estimated carbon saving information in kg-CO2. The carbon footprint
factor in the carbon saving calculation is based on the OECD (2008 Edition).
[CARBON USAGE]: Shows the estimated carbon usage information in kg-CO2. This is the arithmetic
estimation, not actual measurement value. This estimation is based without any options.
Shows the monitor's current firmware version.
Shows the monitor's MAC ADDRESS.


NOTE: If the monitor's main power has been turned off for two weeks, the clock function stops working.
In this case, please set the [DATE & TIME] setting again.
Sets the current year. Press the + or – button on the remote control to cycle to the current year.
Sets the current month. Press the + or – button on the remote control to cycle to the current month.
Sets the current day of the month. Press the + or – button on the remote control to cycle to the current day.
Sets the current time. Highlight the hour field, then press the + or – button on the remote control to cycle to
the current hour, then repeat this for the minutes field.


NOTE: • The monitor's clock is a 24-hour format.

•
If the monitor is at a location that is currently in Daylight Savings, set the TIME field to what
the current time would be when Daylight Savings is not in effect. Then enable the [DAYLIGHT
SAVING] function to have the clock automatically adjust to the current time.
Shows the current date and time. This data does not reflect changes to the Date and Time settings until
SET is pressed on the remote control.
Automatically changes the real-time clock to match Daylight Savings hours.


NOTE: Set the [DATE & TIME] before enabling the [DAYLIGHT SAVING] setting.
Automatically adjusts the current time, when Daylight Saving hours are in effect, based on the start and
end dates selected in this menu.
Set the month, day and time for when Daylight Saving begins.
Set the month, day and time for when Daylight Saving ends.
Set the time difference for the real-time clock adjustment. When Daylight Saving starts, this is the amount
of time the real-time clock will be adjusted.
Sets the monitor's ID number, assigns the monitor to groups.
Sets the monitor's ID number between 1 and 100. This number is also used by the remote control when in
ID mode.


NOTE: It is strongly recommended so that the monitor can be individually identified and controlled.
This function assigns monitors to groups, which gives you the ability to send commands to all monitors,
however, only monitors with the matching Group ID perform the command. Group IDs allow specific groups
of monitors to be targeted using a single command, providing high-speed parallel operation. It is useful
for scenarios such as rapid switching of video inputs or tile matrix configurations within a video wall. The
[GROUP ID] function is used only via RS-232C commands from your software or control system. Monitors
can be assigned to any of the 10 available Group IDs, labeled A-J. Refer to the External_Control.pdf file
(see page 73) for the monitor's command codes.
Selects control terminal, [RS-232C] or [LAN].
Select the language used by the OSD.
English−89