NEC MultiSync UN462A User Manual page 118

MULTI-DSP MENU
TILE MATRIX
H MONITORS
V MONITORS
POSITION
TILE COMP
TILE CUT
TILE MATRIX ENABLE
FRAME COMP
NONE
AUTO
MANUAL
V SCAN REVERSE
NONE
AUTO
MANUAL
NON REVERSE
REVERSE
TILE MATRIX MEM
COMMON
INPUT
Allows one image to be expanded and displayed over multiple screens (up to 100) through a distribution
amplifier.


NOTE: • Low resolution is not suitable for tiling to a large number of monitors.

•
You can operate without a distribution amplifier at a lower number of screens. When [TILE
MATRIX] is active the following functions are not available: [MULTI PICTURE MODE], [TEXT
TICKER], [CLOSED CAPTION], [STILL], [POINT ZOOM].

•
This function is released when selecting [SCREEN SAVER] or [IMAGE FLIP] except for [NONE].

•
Dynamic or Zoom will not work when Tile Matrix is activated.

•
When [DYNAMIC] and [ZOOM] is selected in [ASPECT] while executing [TILE MATRIX], the
setting will be applied after completing the [TILE MATRIX].

•
[POINT ZOOM] function is limited when [TILE MATRIX] is active. Please refer to the [POINT
ZOOM] function for more detail.

•
If Media Player contents are played while [TILE MATRIX] is active, the image play timing might
have a gap within monitors.

•
This function is not available when [SCREEN SAVER] is active.

•
When input signal is HDMI signal with 3840 x 2160 (60 Hz), [TILE MATRIX] is not available.
Number of monitors arranged horizontally.
Number of monitors arranged vertically.
Select which section of the tiled image to be displayed on the monitor.
Compensates for the width of the tile bezels in order to accurately display the image. If [YES] is set to the
[TILE COMP], you can adjust a displayed image size and position by pressing the + button or the - button on
the remote control.
Select a part of image from the displaying image. The selected part is displayed as a full image on the screen.
You can adjust the fame size by the [H MONITORS] and the [V MONITORS] then choose a frame by the
[POSITION]. You can adjust the frame position by pressing the + button or the - button on the remote control.
Enables the Tile Matrix settings.
Sets the tiled image timing to be displayed on the monitor. Large number makes large influence to displayed
image.


NOTE: • The image may be distorted when turning the power on or changing the settings.

•
If [FRAME COMP] is set to [AUTO] or [MANUAL], [V SCAN REVERSE] is not available.
[FRAME COMP] is not available.
Sets display timing to vertical direction of all monitors automatically.
Sets display timing to individual monitor.
Reverse scanning image direction. Normal scanning direction is top to bottom.
NOTE: If [V SCAN REVERSE] is set to [AUTO] or [MANUAL], [FRAME COMP] is not available.
[V SCAN REVERSE] is not available.
Sets automatically calculated image scanning direction to all monitors.
Sets scanning direction to individual monitor.
Sets normal scanning direction and delays 1 frame display image timing.
Reverse scanning direction to individual monitor.
When [INPUT] is selected, the [TILE MATRIX] setting is applied to each signal input.
All settings in the [TILE MATRIX] are saved for all signal inputs.
All settings in the [TILE MATRIX] are saved for the selected signal input.
English−114