System Setup; Extra; Osd Warning - NEC MultiSync E224FL User Manual

System Setup

System Setup Menu
USB
USB Functionality
Auto
On
Off
USB LAN
FACTORY PRESET

Extra

Extra Menu
Input Select
Audio Mute
Audio Volume
DDC/CI
OSD
arning
Oo SignalN This function gives a warning when there is no horizontal or vertical sync. After power is turned on or when there is a
change of input signal, the "Oo Signal" window will appear. The message will close automatically.
Out Of RangeN This function gives a recommendation of the optimized resolution and refresh rate. After the power is turned on,
or there is a change of input signal, or if the video signal doesn't have proper timing, the "Out Of Range" message will appear.
To close the message, please disconnect signal cables.
This operation might increase power consumption. Do you want to continue?N This function notifies of the increase in
power consumption. The message appears when adjusting [DV MODE], [Brightness], or [ECO MODE] settings.
To change the setting, select [Yes] in the message window and press the Right key.
To return without changing, select [No] in the message window and press the Left key.
USB FunctionalityN This message gives a request to set [USB Functionality] setting. See
Selects a transfer speed of USB-C.
USB2.0: The maximum transfer speed is equivalent to USB 2.0 (up to 480 Mbps).
USB3.0: The maximum transfer speed is equivalent to USB 3.0 (up to 5 Gbps).
OOTEN
To avoid data loss, before changing the setting, ensure that no USB storage devices are in use


by the operating system.
Selects how power through the USB Type-A port and USB Type-C port, input signal from USB-C, and
external communication of USB are enabled in relation to the monitor's power status.
OOTEN
• Actual power consumption depends on the connected USB device even when the monitor's


power is off.

• To avoid data loss, before changing the setting, ensure that no USB storage devices are in
use by the operating system.

• When turning on the monitor or after FACTORY PRESET or [USB Functionality] is set to
[Off], USB Functionality message is shown when a USB-C cable is connected to the monitor.
Please select a setting.
Depending on the monitor's power condition.
Always working even when the monitor is in power save mode or power off.
All USB functions (include USB Type-C video signal) are disabled.
Turns the LAN port [On] or [Off].
When using the LAN port, set this [On]. Please refer to
Resets all OSD control settings back to the default settings except [Language].
Selects the input signal source.
Auto, HDMI, DisplayPort, USB-C.
Mutes the speaker or headphone output.
Controls the volume of the speakers or headphones.
Turns the [DDC/CI] function [On] or [Off].
"LAN connection"
English−38
(see page 22).
"USB Functionality" above.