Insinger Commander 18-6 Technical Manual page 11

MECHANICAL CONNECTIONS
All lines must be flushed prior to use to remove debris.
Connect hot water lines for tank fill/booster as tagged
and noted on the installation drawings.
If machine is provided with steam heat, connect the
steam lines and steam condensate lines as tagged
and noted on installation drawings.
Connect the drain lines. Drain lines must be as speci-
fied on installation drawings.
CAUTION:
Drain lines must be as specified on installation
drawings. Drain line should be properly vented and
should have fall of not less than 1/4" to the foot of
proper flow.
CAUTION:
Some area plumbing codes require drains to flow
into an open gap with an opening twice the diameter
of the pipe. Check with your local plumbing codes for
the type of drain connection required.
CAUTION:
Do not reduce the size of lines as specified in
installation drawings. All lines are sized to facilitate
necessary flows, pressures, etc.
HVAC
Ventilation system must be sized to provide adequate
ventilation per machine specs. Refer to spec sheet.
Commander 18-6 Technical Manual 2018
®
9
PART 2 INSTALLATION INSTRUCTIONS
CHEMICALS
Upon the completed installation of the dishwasher,
contact a local detergent/chemical supplier for the
correct chemicals for your soil load and geographical
area.
Electrical connection
dispenser and rinse injector are located inside the
control panel. Refer to the wiring diagram for this
machine for the proper connection points.
Dispensers may be connected on either the primary
voltage side of the machine or the 24VAC control
voltage side.
The detergent density probe should be installed in the
hole provided & labeled in the wash tank.
CAUTION:
When connecting on the 24VAC control voltage
side of the transformer, total KVA must not exceed
www.insingermachine.com
points for the detergent
50VA.
800-344-4802