Insinger Commander 18-6 Technical Manual page 60

COMMANDER 18-6 DOOR TYPE SERIES
STRAIGHT TO CORNER CONVERSION
DOOR CONVERSION
All 3 doors open on a straight machine; only the front
and right hand doors are used on a corner machine.
1. Remove the door connector bracket between the
left and front doors. Fill the holes with the screws,
flat washers and nuts.
2. Disconnect the link between the left door stud
and the handle. Remove it.
3. Reduce the tension on the springs on the back
of the machine. Test the operation of the doors. It
may be necessary to remove the springs and turn
the mounting angle upside down. Use 2 people,
a 1/2 diameter rod and extreme care when
disconnecting and reattaching springs.
4. Make sure that the door magnet is on an
operating door.
TRACK CONVERSION
Current Track Assembly #1550-28
1. Remove item #2 Track Fence from its position on
the front of the track.
2. Place on the left side of the track (at the non-
opening door) by inserting studs into the holes.
3. The angle must face towards the inside of the
machine. The rack will be sliding over the surface
of this angle.
Early Track Assembly #1550-28 rev A
1. Remove #1550-14-2 Vertical from its position on
the front of the track.
2. Install #1550-14-3 Cross Track - Closed End on
the left side (at the non-opening door).
3. Install #1550-14-5 Cross Track - Open End on the
right side (at the opening door).
4. Track arrangement should now match the
view on the left of the drawing labeled COR-
NER SET-UP. If any parts are missing, contact
parts@insingermachine.com.
Commander 18-6 Technical Manual 2018
®
PART 8 STRAIGHT TO CORNER CONVERSION
58
LEFT TO RIGHT CONFIGURATION
See Installation Drawing : Commander 18-6C.
Note how the machine is positioned in a left hand
comer.
For installation into a right hand corner, rotate the
unit 90 degrees clockwise. This constitutes the
conversion procedure.
www.insingermachine.com 800-344-4802