Operating Instructions; Initial Start-Up; Continuing Operation - Insinger RL-30 Technical Manual

Undercounter dishwasher installation, operation and maintenance instructions
Hide thumbs Also See for RL-30:
Table of Contents

Advertisement

OPERATING INSTRUCTIONS

Turn on the main power, S1. The machine will fill.
the booster tank fills and continues until the wash
tank of the machine is full.* Once the wash tank is
full the booster tank heater (R1) is turned "on". Once
the booster has reached operating temperature
185°F (85°C) (set by B1) the wash tank heater (R2)
is activated until optimal wash temperature 158°F
(70°C) (set by B2) is reached.
Power switch on (Green button)
Power light illuminates
Rinse solenoid opens
Rinse booster fills
Wash tank fills until pressure switch is closed B3
Rinse tank heater turned "ON"
Rinse temperature reached
TempGuard™ light turns "ON"
Wash tank heater is turned "ON"
Wash temperature reached
Depress "Cycle Start" switch
Cycle light illuminates
Cam timer starts
Rinse shot (~2 sec)
Wash cycle (~101 sec)
Dwell (~3 sec)
Rinse Cycle (~11 sec)
Drain cycle (0-1 min)
Dwell (~3 sec)
Cam timer stops
RL-30 Undercounter DOC 6_2010
®

Initial Start-Up

S1
H1
Y1 (Only if door is closed)
R1
B1
H5
R2
B2

Continuing Operation

S3
H2
D1
D1 cam 3
D1 cam 2
D1 cam 3
D1 cam 3
PART 3 OPERATING INSTRUCTIONS
At any point during the heating cycle of the booster
and/or the wash tank, a cycle may be started
by pressing the cycle switch (S4). If final rinse
temperature has been achieved the unit will run
a normal 2 minute cycle and stop. If final rinse
temperature has not been achieved the unit will stay
in wash mode until the final rinse reaches preset
temperature (TempGuard
adjustable by B7, TempGuard
(initiates solenoid Y1)
(initiates solenoid KM3)
(initiates solenoid Y1)
(initiates timer KA5)
9
www.insingermachine.com
feature). TempGuard
thermostat.
*The water level in the wash tank
should be within a 1/2" from the
top of the overflow drain pipe.
CAUTION:
Do not place anything on the
open door.
NOTE:
The booster heat
and wash heat
thermostat are
located behind the
front kick panel.
Booster B1
Wash B2
Turn clockwise
to increase set
temperature.
TempGuard
WARNING:
!
Do not open the
door while the
program is running.
There is a risk of
hot water spraying
out of the machine.
(The unit is
equipped with a
door safety switch,
located behind the
door.)
800-344-4802
is
B7

Advertisement

Table of Contents
loading

Table of Contents