Installation Instructions; Electrical Requirements; Electrical Connections - Insinger ENSIGN 40-2 Technical Manual

INSTALLATION INSTRUCTIONS

Machine Specifications
Insinger Model Ensign 40-2 stainless steel counter
type dishwasher with automatic timing of the wash
and rinse cycle with either electric immersion
heater for tank heat and electric heat exchange
booster for rinse or steam coils for tank heat and
steam heat exchange booster for rinse.

ELECTRICAL REQUIREMENTS

(specified by end-user):
1/2 HP, 110-120/240 single phase or 208-
220/460VAC three phase, 60 cycle. Motor oper-
ates through a timed cycle controller. Rinse oper-
ates through a 24VAC solenoid valve actuated by
the timed cycle controller.
FEED:
Side door loading, counter top installation. Direc-
tion of feed specified by end-user.
Tools:
No special tools required for cleaning or mainte-
nance. Cleanout brush provided for the spray
pipes. Machine must be welded into the tabletop
(unless provided with a stand).
DISHBASKETS:
16" square plastic inserts.
Placement
Carefully uncrate machine. Take caution not to
damage components which may be mounted on
the top or sides of the machine. Set unit in the table
cut-out. Refer to installation drawing in this section
for table cut-out dimensions. Weld the dish ma-
chine into the table. Install temp gauges.

Electrical Connections

Connect electrical lines sized for the correct volt-
age, current and phase of the machine. These
should agree with the machine requirements
indicated on the nameplate and labels on the
control panel. A single-point electrical connection
is provided for the pumps, control circuit, and wash
tank heater.
Ensign 40-2 DOC ENS-ES 1.0 04
PART 2 INSTALLATION INSTRUCTIONS
If an electric booster is provided, connect power
directly to the booster.
CAUTION:
Connections must be made to a circuit breaker
or fused disconnect as provided by the
end-user and required by local codes.
A laminated wiring diagram is inside the control panel.
Chemicals
Upon the completed installation of the dishwasher,
contact a local detergent/chemical supplier for the
correct chemicals for your soil load and geographi-
cal area.
Electrical connection points for the detergent
dispenser and rinse injector are located inside the
control panel. Refer to the wiring diagram for this
machine for the proper connection points.
Dispensers may be connected on either the pri-
mary voltage side of the machine or the 24VAC
control voltage side.
CAUTION:
When connecting on the 24VAC control voltage side
of the transformer, total VA must not exceed 50VA.
Tabling
Load and unload tables should be pitched towards
the machine to return excess water into the ma-
chine
www.insingermachine.com 800-344-4802