Table of Contents
Advertisement
LT-40 LOW TEMPERATURE CHEMICAL
SANITIZING DOOR TYPE SERIES
INSTALLATION INSTRUCTIONS
These installation instructions are intended for
qualified equipment installers.
Placement
Carefully uncrate the machine. Take caution not to
damage components which may be mounted on the
top or sides of the machine.
Set the unit in place and adjust the feet to level the
machine.
Tabling
Load and unload tables should be pitched towards the
machine to return excess water into the machine.
Fasten the tables to the load and unload side of the
machine. Most installations require fastening the turn-
down lip of the dish tables to the side of the machine
with flathead countersunk screws. The table design
should provide horizontal clearance of 30" for servicing.
Electrical Connections
Connect electrical lines sized for the correct voltage,
current and phase of the machine. These should
agree with the machine requirements indicated on the
nameplate and labels on the control panel.
A single-point electrical connection is provided for the
pumps, and control circuit. A laminated wiring diagram
is inside the control panel.
CAUTION:
Connections must be made to a circuit breaker
or fused disconnect as provided by the end-user
and required by local codes.
LT-40 Series Technical Manual 2018
®
PART 2 INSTALLATION INSTRUCTIONS
7
LT-40S ELECTRICAL CHARACTERISTICS
VOLTS
PHASE
FREQUENCY
WASH MOTOR AMPS
TOTAL LOAD
LT-40H ELECTRICAL CHARACTERISTICS
VOLTS
PHASE
FREQUENCY
WASH MOTOR AMPS
TOTAL LOAD
Mechanical Connections
All lines must be flushed prior to use to remove debris.
Connect water line for tank fill as tagged and noted on
the installation drawings.
Connect the drain line. Drain lines must be as specified
on installation drawings.
Drain line should be properly vented and should have
a fall of not less than 1/4" to the foot of proper flow.
www.insingermachine.com
115
230
1
1
60
60
13A
7A
13A
7A
115
230
1
1
60
60
13A
7A
13A
7A
800-344-4802
Advertisement
Table of Contents
