Table of Contents
Advertisement
[215] Cellular Receiver 2 APN
Default ( )
The APN determines the cellular network that the communicator will connect to. This information
is available from your network carrier. Program this section with up to 32 ASCII characters.
NOTE: When a SIM card with a custom APN is used, the unit will not have access to the Internet.
DLS and remote flash can still be done if section [221] is programmed with a valid public
APN.
[216] Cellular Receiver 2 Domain Name
Default ( )
Enter the cellular receiver 2 Domain Name with up to 32 ASCII characters.
Cellular Options
[221] Cellular Public Access Point Name
Default ( )
When the communicator is operating on a private APN, use this section to select a public APN for
DLS and remote firmware update. This information is available from your network carrier. The
APN identifies the public cellular network that the communicator will connect to.
[222] Cellular Login User Name
Default ( )
Some network carriers require you to provide login credentials when connecting to an APN. Pro-
gram your login user name in this section. Format is up to 32 ASCII characters.
[223] Cellular Login Password
Default ( )
Some network carriers require you to provide login credentials when connecting to an APN. Pro-
gram your login Password in this Section. Format is up to 32 ASCII characters.
[224] Cellular Test Transmission Time of Day
Default (9999)
Enter a 4 digit value using the 24-hour clock format (HHMM) to set the test transmission time of
day. Valid range: 00-23 for the hours (HH) and 00-59 for the minutes (MM).
NOTE: To disable the test transmission time of day enter 9999 or FFFF in this section.
The internal date and time will be automatically programmed by the primary receiver only.
[225] Cellular Test Transmission Cycle
Default (000000)
This value represents the interval in between test transmissions in minutes. Valid range: 000000 -
999999 minutes. Once the unit has sent the initial periodic test transmission, all future test trans-
missions will be offset by the programmed number of minutes. See sections [026] - [029].
Table 14: Cellular Test Transmission Interval
Test Transmission Interval
Programmed Minutes
NOTE: Minimum value is 000005 minutes. Programming an interval that is less than 5 minutes
will disable test transmission.
[226] Cellular Trouble Delay
Default (0A)
This option is used to program the delay, in minutes, for reporting a cellular trouble delay. Valid
entries are 00 - FF. (e.g., for a 10 minute cellular trouble delay enter: 0A). There is no reporting
delay if value is programmed as 00.
SMS Event Notification/Command and Control Options
When an event is triggered by the panel and SMS notification is ON in section [301] toggle option
[1], an SMS message is created and sent to the SMS telephone numbers programmed in sections
[311]-[342] for event types specified in sections [343]-[374] if toggle [7] is ON. The system will
make one attempt to send the SMS message to each of the programed telephone numbers, starting
HSPA(3G) Alarm Communicator Installation Manual
Daily
001440
Weekly
Monthly
010080
043200
34
Hide quick links:
Advertisement
Table of Contents
