Cellular Receiver 2 Options - DSC TL2803GR Installation Manual

[203] Cellular Receiver 1 Address
Default (000.000.000.000)
Enter the cellular receiver 1 IP address. This information will be provided by your central station
system administrator. Each 3-digit segment of the address must be within a valid range of 000-
255.
NOTE: When a valid IP address has been entered, the cellular is enabled and will communicate
events over the cellular channel.
[204] Cellular Receiver 1 Port
Default (0BF5/3061)
This section determines the port used by cellular receiver 1. Change the default value of this port
when your installation is located behind a firewall, and must be assigned a particular port number
as determined by your central station system administrator. Valid range: 0000 - FFFF.
NOTE: Programming this section with 0000 will disable the receiver.
[205] Cellular Receiver 1 APN
Default ( )
The Access Point Name (APN) determines the cellular network that the communicator will con-
nect to. This information is available from your network carrier. Program this section as 32 ASCII
characters.
NOTE: When a SIM card with a custom APN is used, the unit will not have access to the Internet.
DLS and remote flash can still be done if section [221] is programmed with a valid public
APN.
[206] Cellular Receiver 1 Domain Name
Default ( )
Enter the Domain Name as 32 ASCII characters. This information will be provided by your central
station system administrator.

Cellular Receiver 2 Options

[211] Cellular Receiver 2 Account Code
Default (0000000000)
The account code is used by the central station to distinguish between different transmitters. This
account code is used when transmitting signals to the central station receiver. Signals received on
the panel will use the panel account number. Valid range: 0000000001 - FFFFFFFFFE.
NOTE: Programming this section as all 0 or F will cause a module configuration trouble (yellow
LED = 12 flashes).
[212] Cellular Receiver 2 DNIS
Default (000000)
The DNIS is used in addition to the account code to identify the communicator module at the cen-
tral station. Valid range: 000000 - 099999. Values are entered as a 0 followed by the 5 digit DNIS
value. Format is BCD.
NOTE: Each Ethernet/cellular receiver must be programmed with a unique DNIS.
[213] Cellular Receiver 2 Address
Default (000.000.000.000)
Enter the cellular receiver 2 IP address. This IP address will be provided by your central station.
Format is 4 fields, each field is 3-digit decimal. Valid range: 000 - 255.
NOTE: When a valid address has been entered, cellular receiver 2 is enabled and will communi-
cate events over the cellular path.
[214] Cellular Receiver 2 Port
Default (0BF5/3061)
This section defines the port of cellular receiver 2. Change the value of this port when your instal-
lation is located behind a firewall and must be assigned a particular port number, as determined by
your central station system administrator. Valid range: 0000 - FFFF.
NOTE: Do not program cellular receiver 1 and cellular receiver 2 to communicate to the same
receiver.
HSPA(3G) Alarm Communicator Installation Manual
33