DSC TL2803GR Installation Manual page 10

e. Locate the screw hole on the right side wall of the
panel. See Figure 2 (screw). Line up the assem-
bled communicator with the right side wall of the
panel and, using the screw provided, secure the
mounting bracket to the panel.
f. Attach the other end of the PC-LINK cable to the
communicator (red wire goes on the right-hand pin
of the communicator PC-LINK header (see Figure
3)).
g. Using light pressure (finger tight only), attach the
supplied white quad band whip antenna to the
threaded antenna connection point at top of the
panel.
WARNING! - 3G2080(R)/TL2803G(R) modules are
power limited. Do not route any wiring over the cir-
cuit board. Maintain at least 1in. (25.4mm) separa-
tion between circuit board and wiring. A minimum
of ¼ in. (7mm) separation must be maintained at
all points between non-power limited wiring and
power limited wiring.
3. To electrically connect the communicator to the panel, perform the following steps (See Figure 3).
a. Disconnect both AC power and battery connections from the panel, and disconnect tele-
phone line.
b. Confirm that the SIM card is inserted in the holder and locked.
Figure 3:Communicator Wiring Diagram
Input Ratings:
+10.8V ~ +12.5 VDC
90mA(3G2080(R))/120mA(TL2803G(R)) standby;
400mA alarm
DSC Panel min. power requirements:
- 16.5 VAC 40 VA transformer;
- 12 VDC 7Ah battery
HS2016/2032/2064/2128
AC AC
AUX+
4. Install Network Cable (TL2803G(R) only). Route the CAT 5 Ethernet cable through the back of
the panel and plug it into the communicator's RJ45 jack.
NOTE: Before leaving the premises the Ethernet communication lines must first be connected to
an approved (acceptable to local authorities) type NID. All wiring shall be performed
according to the local electrical codes.
HSPA(3G) Alarm Communicator Installation Manual
PCLINK_2
UA621
RS-422
To 3rd party device
PGM1 PGM3
Z1 COM Z2 Z3 COM Z4 Z5 COM
PGM2 PGM4
Figure 2:HS2016/2032/2064/2128 Control Panel
To external antenna
L
SIM
o
3G Radio
c
k
DSC
TL2803G(R)
UA601
3G2080(R)
PC-LINK
Red
Red
Z6 Z7 COM Z8 RING TIP T-1 R-1
10
quad band
PC-Link
whip antenna
cable connector
Use light pressure
to attach antenna
finger tight
GSM Radio
HS2016/2032/2064/2128
1
AUDIO/DEFAULT
Jumper pins 4 and 5
to reset.
Network Link
YELLOW
RJ-45
COM
From NID
TL2803G(R)
Use only CAT5
Supervised
Maximum cable length
100 m (328 ft)
only.
RJ-45
screw