Table of Contents
Advertisement
8. Receiver 4 initialized
For example, the radio initialization status code 1--45--- indicates that the radio has been powered
up, the radio is attached to the network, and receiver 1 has been initialized. This code would
update to 1--45678 when receivers 2, 3, and 4 are initialized.
If the radio initialization status code does not indicate any problems, proceed with installation as
per this manual. If troubles are reported, reset the initialization process. If this action does not fix
the problem, refer to the trouble shooting section in this manual.
The following table shows each digit position in the status code, each digit's value and its assigned
meaning in the eight-digit code:
Table 19: Radio Initialization Status - 1-8 bits completion
Bit
Not Completed
Completed
[987] Language Version
This section will display the current language version of the communicator.
[988] DNS 1 IP Address
This section will display the IP address of DNS Server 1. This is useful when the unit is configured
for DHCP and you need to see the IP address that was assigned to the device by the DHCP Server.
This value is programmed in Section [007] or assigned by DHCP.
[989] DNS 2 IP Address
This section will display the IP address of DNS Server 2. This is useful when the unit is configured
for DHCP and you need to see the IP address that was assigned to the device by the DHCP server.
This value is programmed in section [008] or assigned by DHCP.
[990] Boot Loader Version
This section will display the current boot loader version of the communicator.
[991] Firmware Version
This section will display the current firmware version of the device. Update worksheets with new
version after a flash update is completed.
[992] Ethernet IP Address
This section will display the IP address of the Ethernet connection. This value is programmed in
section [001] or assigned by DHCP.
[993] Ethernet Gateway Address
This section will display the IP address of the Ethernet gateway. This value is programmed in sec-
tion [003] or assigned by DHCP.
[994] Cellular IP Address
This section will display the current dynamic IP address assigned by DHCP to the cellular connec-
tion.
NOTE: Cellular uses DHCP (dynamic IP) only. The cellular IP address is always provided by the
cellular network (i.e., not programmable).
[995] SIM Number
This section will display the Subscriber Identity Module (SIM) number of the SIM card installed
in the communicator. Format is: Major Industry Identifier (2 digits); Mobile Country Code (2 or 3
digits); Mobile Network Code (2 - 3 digits); Unique Number (10 - 12 digits); and Checksum (1
digit). Valid SIM numbers range is: 18 - 21 numbers. This number is printed on the SIM and the
outside of the communicator carton.
NOTE: The checksum digit is omitted on 19-digit SIM card numbers.
[996] Cellular Telephone Number
NOTE: This section will display the cellular telephone number of the SIM. This telephone num-
ber is required by the Installer for DLS and remote firmware (flash) update. Users can
access this telephone number by entering [*] [6] < > "Cellular Phone No." to display the
phone number.
HSPA(3G) Alarm Communicator Installation Manual
1
2
-
-
1
2
3
4
5
-
-
-
3
4
5
41
6
7
8
-
-
-
6
7
8
Hide quick links:
Advertisement
Table of Contents
