Operation - Ranger Laser-Spot LS43B Installation And Operation Manual

Final Checklist Before Operation
Make sure these things have been done
• Review the Installation Checklist to make sure all steps have been performed.
• Make sure the Balancer is getting power from the power source.
• Check to see that all Anchor Bolts are in position and tightened.
• Leave the Manual with the owner/operator.

Operation

This section describes how to use your LS43B Wheel Balancer.
About the LS43B Wheel Balancer
The LS43B Wheel Balancer is a computer-controlled Wheel Balancer that provides fast, accurate
Wheel balancing for a wide variety of Wheels. It optimizes Wheel weight placement using Laser-Spot™
technology, which indicates weight placements on the Wheel using a red laser line.
⚠
DANGER
Usage Precautions
Keep the following in mind while you use your Balancer:
• Make a visual inspection of the unit
any issues. Instead, take the unit out of service, then contact your dealer, visit
www.bendpak.com/support/, or call (805) 933-9970.
• Keep the work area clean and well lit. Dirty, cluttered, and dark work areas increase the chances of
an accident happening.
• Do not remove the Storage Trays unless instructed to do so by Ranger Support. There are no user
serviceable parts underneath.
• When using the product, you
toed work boots, and an industrial back belt. Keep hair, jewelry, and clothing away from the unit.
• When using the product,
times
: safety glasses, a face shield, or protective goggles.
⚠
WARNING
• Only authorized personnel may use the unit. Keep children and untrained personnel away.
• Do not use the unit in a wet environment or expose it to rain or excess moisture.
• If an extension cord is necessary, a cord with a current rating equal to or more than that of the
equipment must be used. Cords rated for less current than the equipment may overheat. Care
should be taken to arrange the cord so that it will not be tripped over or pulled.
• Do not use the unit in the vicinity of open containers of flammable liquids.
• Clean the unit according to the instructions in Maintenance.
• Read the entire Installation and Operation Manual before using the unit.
LS43B Laser-Spot™ Wheel Balancer
before
Do not look directly into the laser; you will damage your eyes and could be blinded.
before each use
must wear appropriate work clothing: leather gloves, non-skid steel-
the operator must wear ANSI-approved eye protection at all
Always wear ANSI-approved eye protection. Although rare, an accident could
cause significant injuries to your eyes.
using your Balancer:
. Do not operate your Balancer if you find
Do not look into the laser.
22
P/N 5900086 — Rev. A1 — 12/212018