Ranger Laser-Spot LS43B Installation And Operation Manual page 43

Weight Location Verification Test
The Weight Location Verification Test ensures the Balancer is producing accurate readings.
Before performing the Weight Location Verification Test, ma ke sure the Balancer is anchored down
and/or rigid to the floor and that the shaft and centering cones are clean and undamaged. Dirt or
damage can cause inaccurate readings.
Important:
A steel, undamaged Wheel of a size you commonly balance is needed for this procedure.
To perform the Weight Location Verification Test:
1. Balance the Wheel to fully balanced; 00 displays in the Inner and Outer Windows.
2. Program the correct Distance, Width, and Diameter values into the Balancer using the Inner Arm
and the Outer Arm or entering them manually.
3. Press and hold the C and T buttons on the Control Panel until the Placement Indicators stop
flashing and CAL CAL appears.
4. Lower the Hood.
The Wheel spins briefly, then stops.
Add 100 appears (Add 3.5 if oz is selected).
5. Turn the Wheel by hand until the Inner Placement Indicators are all lit.
6. Add the 100-gram Calibration Weight (Clip-On) to the
pointing (Top Dead Center or 12 o'clock).
7. Close the Hood.
The Wheel spins briefly, then stops.
Add 100 appears again.
8. Turn the Wheel by hand until the Outer Placement Indicators are all lit.
9. Remove the 100-gram Calibration Weight from the Inner Edge of the Wheel and add it to the
Outer Edge
10. Close the Hood.
The Wheel spins briefly, then stops.
End CAL appears.
11. Remove the 100-gram Calibration Weight from the Wheel.
The Weight Location Verification Test is complete.
LS43B Laser-Spot™ Wheel Balancer
Pay close attention to this procedure. If not done correctly, the Balancer will not
produce accurate readings, leading to Wheels not being balanced correctly.
where the laser is pointing (Top Dead Center or 12 o'clock).
Inner Edge
43
of the Wheel where the laser is
P/N 5900086 — Rev. A1 — 12/212018