Ranger Laser-Spot LS43B Installation And Operation Manual page 21

5. Hammer or mallet the Anchor Bolt the rest of the way down into the hole.
Stop when the Washer is snug against the Base Plate.
6. Wrench each Nut
Important:
Wrenching the Nut forces the Wedge up, forcing out the Expansion Sleeve and pressing it tightly
against the Concrete.
Connect to a Power Source
The Balancer is configured to use a 220 VAC, 50/60 Hz power source. The Power Cord must be
connected to a 50 amp breaker.
A Power Cord with no Plug is provided with the unit. You need to have a licensed, certified Electrician
wire the open end of the Power Cord to an appropriate 220 VAC Plug.
Refer to
Wiring Diagram
⚠
WARNING
Additional electrical information:
• Operation with no Ground can damage electronics and could create a shock hazard.
• Damage caused by improper electrical installation voids the warranty.
• Most electrical codes require "hard-wiring" when the machine is bolted to the floor. Consult a
licensed Electrician regarding the applicable codes for your location.
Test the Balancer
To test the Balancer to see if it is ready for normal operation:
1. Turn the Balancer On/Off switch to On.
The Display Panel shows Bal on the Inner Window and 11 on the Outer Window, followed by
default Wheel dimensions.
2. Mount a standard steel Wheel of a size you most often balance.
Refer to
3. Move the Inner Arm to the Inner Edge of the Wheel; let go when you hear the Balancer beep.
4. Move the Outer Arm to the outer Edge of the Wheel; let go when you hear the Balancer beep.
5. Lower the Hood.
The Wheel starts to spin clockwise when the Hood is lowered.
If the Wheel does not spin or spins counterclockwise instead of clockwise, turn the Balancer off
and contact your dealer, visit www.bendpak.com/support/, or call (805) 933-9970.
6. Put the Outer Arm against the Outer Edge and wait for the beep.
If there is no beep, refer to
LS43B Laser-Spot™ Wheel Balancer
clockwise
not
Do use an impact wrench to torque the Anchor Bolts.
for a wiring diagram.
All electrical work
Mounting a Wheel
Troubleshooting
to the recommended torque, 60 – 70 lbf-ft / 81 – 95 N-m.
must be done by a licensed, certified Electrician
for specific mounting instructions.
for more information.
21
P/N 5900086 — Rev. A1 — 12/212018
.