Ranger Laser-Spot LS43B Installation And Operation Manual page 16

Installing the Mount Box
The Mount Box holds both the Hood Mount Bar and the Outer Arm Mount Bar. It installs on the back
of the Balancer on the left side.
Note: You
To install the Mount Box:
1. Locate the Mount Box and the four bolts, four washers, and four split lock washers required to
install it.
– The Mount Box comes in a separate box that also includes bolts and washers in a bag.
– The Mount Box connects to the back of the Balancer using four hex bolts, four washers, and
four split lock washers.
– The cover of the Mount Box comes already in place. However, it is easier to install the Mount
Box if you remove the Cover. To do this, remove the two 3 mm hex bolts on each side of the
Cover.
2. Using four bolts, washers, and split lock washers, connect the Mount Box to the back of the
Balancer; tighten securely with a wrench.
The Mount Box is now ready to support the Hood Mount Bar and the Outer Arm Mount Bar.
LS43B Laser-Spot™ Wheel Balancer
must
install the Mount Box before you can install the Hood or the Outer Arm.
16
P/N 5900086 — Rev. A1 — 12/212018